From: George Spahl (g.spahl@xxxxxxxxxxxxx)
Date: Fri Jun 14 2002 - 09:45:27 GMT-3
Jason,
Here's a good link that will probably help you straighten that out.
Look under "New Dialer Profile Model". It tells how calls are bound to
dialer profiles.
www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fdial_c
/fnsprt5/dcdiprof.htm#39936
Hope this helps!
George
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Jason Wydra
Sent: Thursday, June 13, 2002 10:57 PM
To: ccielab@groupstudy.com
Subject: Dialer interfaces
I have two dialer interfaces on my hub router both point to dial pool 1
on the BRI (Dial pool-member 1). The spoke routers have dialer
interfaces pointing to the hub. I can only get the connection to come up
when I remove one of the dialer interfaces on the hub. If I try to
configure more than one dialer interface with dial pool 1 I get a
failure when trying to call from the spokes. Debug shows busy signal on
spoke and unbindable on hub. Please help.
Jason
---------------------------------
Do You Yahoo!?
Sign-up for Video Highlights of 2002 FIFA World Cup
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:33 GMT-3