From: MERRILL, JAMES D (AIT) (jm8752@xxxxxxx)
Date: Wed Jun 12 2002 - 15:50:16 GMT-3
Try setting the Speed and duplex on both routers and the switch they're
plugged into. I had a problem on my first lab attempt because I let the
router and switch auto configure. As soon as I set the switch and router I
was able to pass traffic.
This problem cost me a bout 2 hours on the lab. I would have left it for
later in the day but the lab had 80% of the network running across that ISL
trunk.
If that doesn't work try doing each encap type on the primary interface and
not on sub-interfaces.
-----Original Message-----
From: Michael Popovich [mailto:m.popovich@mchsi.com]
Sent: Wednesday, June 12, 2002 11:44 AM
To: CCIE GROUPSTUDY
Subject: IPX Network detection
I have heard the solution for this and am testing it in my lab only I am
unsuccessful.
R7 is the IPX router that I don't know the network number to. Here is the
config on the FastEthernet interface:
interface FastEthernet0/0
ip address 150.50.7.7 255.255.255.128
duplex auto
speed auto
ipx encapsulation SNAP
ipx network AA
R5 is the router that is trying to detect the network number on it's
Ethernet
segment:
interface FastEthernet0/0
bandwidth 100000
ip address 150.50.7.5 255.255.255.128
duplex auto
speed auto
no ipx route-cache
!
interface FastEthernet0/0.1
ipx network CC
!
interface FastEthernet0/0.2
ipx network DD encapsulation SNAP
!
interface FastEthernet0/0.3
ipx network EE encapsulation ARPA
!
interface FastEthernet0/0.4
ipx network BB encapsulation SAP
I do a "debug ipx packet" and I don't see anything at all. If I "debug ipx
all" I see SAP and RIP updates but that's it, nothing that tells me the
correct network number.
Any ideas??
TIA
MP
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:31 GMT-3