From: Thomas Trygar (trygar@xxxxxxxx)
Date: Thu Jun 06 2002 - 10:10:31 GMT-3
This might be limited (not allowed) in lab, but you could configure:
r1 to r2 link as RIPv1 and "configure the send/receive version 1 only under e0
and r1 config"
and "configure the send/receive version 1 only under loop0"
r2 to r3 link as RIPv2 and "configure the send/receive version 2 only under e1
and r3 config"
I re-read original email and they mentioned Loopbacks specifically.
R5(config)#int lo0
R5(config-if)#ip rip ?
authentication Authentication control
receive advertisement reception
send advertisement transmission
v2-broadcast send ip broadcast v2 update
R5(config-if)#ip rip receive ?
version version control
R5(config-if)#ip rip receive version ?
1 RIP version 1
2 RIP version 2
<cr>
But you'd probably not be allowed to modify versions in the lab. "Ahh, Calgon
take me away."
Tom
"Hung, Sing-Yu" wrote:
> Hi,
>
> If standard access-list, r2 lo0 both not send to r1 and to r3.And I
> haven't ideal how to use extended list for distribution.Please help?
>
> Bradford Hung
>
> Pacific Century CyberWorks
>
> -----Original Message-----
> From: steven.j.nelson@bt.com [mailto:steven.j.nelson@bt.com]
> Sent: Thursday, June 06, 2002 8:11 PM
> To: Hung, Sing-Yu; ccielab@groupstudy.com
> Subject: RE: RIP route distribute
>
> Distribute list, perhaps ?
>
> -----Original Message-----
> From: Hung, Sing-Yu [mailto:Sing-Yu.Hung@pccw.com]
> Sent: 06 June 2002 12:56
> To: ccielab@groupstudy.com
> Subject: RIP route distribute
>
> Dear,
>
> r1----------------rip----------(e0)r2(e1)-----------rip-----------r3
>
> R2 have loop0: 50.0.0.1/24
> r2 e0:172.16.11.1/24
> r2 e1:172.16.12.1/24
>
> If someone can tell me how to config on r2 such that r2 lo0 is only sand to
> r1 and not to r3?
>
> Bradford Hung
>
> Pacific Century CyberWorks
> Tel: 288 33125
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:27 GMT-3