From: 송영준 (inlink@xxxxxxxxxx)
Date: Sat Jun 01 2002 - 21:08:07 GMT-3
Hi,all
r1------ Fr1---------------Fr2-------- r4
| tunnel |
r2 r3
1. Fr1 : 2501
Fr2 : 2501
I tried to combine two combine 2 2501 to act as a single frame relay switch.
But Combine 2ea 2501 is not working as FR switch.
Tunnel interface(eth) status is not active pvc. (T T)
I wonder that this config is whether possible or impossible.
Thanks for your advice...
[ Fr1 config ]
frame-relay switching
!
interface Tunnel0
no ip address
tunnel source Ethernet0
tunnel destination 192.168.1.2
!
interface Ethernet0
ip address 192.168.1.1 255.255.255.0
!
interface Serial0
no ip address
encapsulation frame-relay
clockrate 125000
frame-relay lmi-type ansi
frame-relay intf-type dce
frame-relay route 16 interface Tunnel0 18
frame-relay route 21 interface Tunnel0 19
frame-relay route 23 interface Serial1 24
frame-relay route 25 interface Serial1 26
!
interface Serial1
no ip address
encapsulation frame-relay
frame-relay lmi-type ansi
frame-relay intf-type dce
frame-relay route 17 interface Tunnel0 20
frame-relay route 24 interface Serial0 23
frame-relay route 26 interface Serial0 25
!
ip classless
!
[ Fr 2]
frame-relay switching
!
interface Tunnel0
no ip address
tunnel source Ethernet0
tunnel destination 192.168.1.1
!
interface Ethernet0
ip address 192.168.1.2 255.255.255.0
!
interface Serial0
no ip address
encapsulation frame-relay
no fair-queue
clockrate 125000
frame-relay lmi-type ansi
frame-relay intf-type dce
frame-relay route 18 interface Tunnel0 16
frame-relay route 19 interface Tunnel0 21
frame-relay route 20 interface Tunnel0 17
!
[Fr2 config ]
---^----^---Assistant Manager / General Enterprise Team
@ () @ Comtec Informations Co., Ltd
Song young jun inlink@dreamx.net
Office : 82-2-3289-0244, Mobile :82-18-293-3086
This archive was generated by hypermail 2.1.4 : Tue Jul 02 2002 - 08:12:20 GMT-3