From: alain faure (alainfaure@xxxxxxxx)
Date: Wed May 29 2002 - 05:29:22 GMT-3
Hello,
Ok, maybye i failled in the configuration, i will go back to my routers again,
to check it.
Thanks
Best regards
--- Oliver Boehmer <oboehmer@cisco.com> a icrit : > Hi Irene,
>
> the rule is: Every OSPF process will chose a different RID, and the order
> depends on the configuration (i.e. after a reload, IOS allocates a RID in
> the order the processes are defined in the configuration). The algorithm
> each process uses is the same (i.e. loopbacks first, then highest IP
> address, etc.).
> If you have 10 processes, but only 9 interfaces with IP addresses, the last
> OSPF process fails to start.
>
> oli
>
>
> At 11:54 28.05.2002 +0200, GOLBERY Irhne wrote:
> >Hello,
> >
> >
> >How does ospf works when there is in a routeur multiple ospf processes and
> >one or multiple loopack ?
> >What is the Rid choice for each ospf process ? ( What is the rule ?)
> >
> >Thanks for your help
> >
> >Irene.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:11 GMT-3