From: D. J. Jones (meganac@xxxxxxxxx)
Date: Wed May 15 2002 - 21:53:54 GMT-3
I stand corrected. Using multiple ip route 0.0.0.0 0.0.0.0 commands to
configure a default route, traffic is
load-balanced over the multiple routes per:
http://www.cisco.com/warp/public/105/default.html
..dj
----- Original Message -----
From: "D. J. Jones" <meganac@attbi.com>
To: <Giveortake@aol.com>; <ccielab@groupstudy.com>
Sent: Wednesday, May 15, 2002 5:40 PM
Subject: Re: Two Default Routes which path?
> I don't believe the packets will alternate based on sessions. Once the
> first route
> is installed and used, then the router will continue to use that until the
> link goes down.
> Then it will use the route over serial 1.
> ----- Original Message -----
> From: <Giveortake@aol.com>
> To: <ccielab@groupstudy.com>
> Sent: Monday, May 13, 2002 6:16 PM
> Subject: Two Default Routes which path?
>
>
> > If I have say a 25xx router or any router with two serial interfaces,
and
> I
> > put a default route say
> >
> > ip route 0.0.0.0 0.0.0.0 serial 0
> > ip route 0.0.0.0 0.0.0.0 serial 1
> >
> > What will happen to the packets if there is no route in the table?
> Will
> > they all go down the first default route? Will the packets alternate
> based
> > on sessions?
> >
> > Amazing how many smart people with lots of experience I have asked that
do
> > not know the answer to this question including myself!
> >
> > Thanks,
> >
> > David
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:57 GMT-3