From: omer@xxxxxxxxxx
Date: Wed May 15 2002 - 20:49:11 GMT-3
if it is cat6k, then you might be able to use
show mls entry cef ip adjacency
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_6_2/cmd_ref/sh_m
l_n.htm#xtocid2461915
as the layer3 cef adjacencies are actually maintained
on the pfc of the supervisor engine card.
but beware, this is too product specific.
On Wed, 15 May 2002, "Jason" wrote
>
> The ideas you guys have given are good but the
problem is that the
> management IP address is on a different subnet then
the hosts that are
> on the switch.
>
> Jason
>
> -----Original Message-----
> From: nobody@groupstudy.com
[mailto:nobody@groupstudy.com] On Behalf Of
> JAKE REYNOLDS
> Sent: Wednesday, May 15, 2002 4:26 PM
> To: 'ccielab@groupstudy.com'
> Subject: RE: RARPing on a Cat IOS switch
>
> 1. If you know the range you could just install a
simple tool like IP
> Ultra
> Scan and tell it to scan for active hosts. That will
tell you all IP's
> of
> all active hosts and you can then filter by mac.
>
> 2. If you are using a CAT 5/6K with some kind of
router on a stick then
> you
> could just session to the router and sho arp.
>
> I may be overthinking it but I can't think of an
easier way to do it.
>
> Jake
>
> -----Original Message-----
> From: jgraun@attbi.com [mailto:jgraun@attbi.com]
> Sent: Wednesday, May 15, 2002 3:52 PM
> To: ccielab@groupstudy.com
> Subject: RARPing on a Cat IOS switch
>
>
> Does anybody know how to get the IP address of a
device
> plugged directly into the switch if all I have is the
> mac address?
>
> Thanks
>
> Jason
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:57 GMT-3