From: Frank Kim (frank@xxxxxxxxxxxxx)
Date: Wed Apr 24 2002 - 19:26:49 GMT-3
Tom/Brian,
Thanks. That command will only work for the PA-MCX-8TE1+ and the
PA-VXC-2TE1+ for the 7200/7500 modules. Unfortunately, this
AS54-DFC-8CT1 card for the AS5400 is a bit different. I'm still trying to
find out if it's possible to take a AS54-DFC-8CT1 and turn it into an
AS54-DFC-8CE1. I will keep you all updated. Thanks.
-Frank
On Wed, 24 Apr 2002, Thomas Trygar wrote:
> Frank,
>
> router(config)# card type t1 1
>
> Used on a 7206 router with PA-MC-8TE1+ modules in slot 1.
> If you card supports either a T1 or E1 mode, above command should work.
>
> Tom
>
> Brian Dennis wrote:
>
> > Frank,
> > I've changed the MFT trunks on the 3810's from E1's to T1's before. If I
> > remember right, it was a few years ago, I went into ROMMON mode and
> > typed something along the lines of "trunk 0 t1" to switch it to a T1
> > from an E1.
> >
> > I would be surprised if the hardware for the 8 port T1 module is any
> > different than an 8 port E1 module.
> >
> > Brian Dennis, CCIE #2210 (R&S/ISP Dial)
> > bdennis@5g.net
> > 5G Networks, Inc.
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> > Frank Kim
> > Sent: Wednesday, April 24, 2002 1:45 PM
> > To: ccielab@groupstudy.com
> > Subject: OT: AS5350 T1/E1 question
> >
> > Hi Folks,
> > I've heard that you can actually take a 8 port T1 module and do a
> > firmware
> > upgrade to convert it into a 8 port E1 module on an AS5350/AS5400
> > router. Can anyone confirm if this is true or not? Thanks.
> >
> > -Frank
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:19 GMT-3