From: André Bersvendsen (an-bersv@xxxxxxxxx)
Date: Wed Apr 24 2002 - 16:42:11 GMT-3
If you are not allowed to use broadcast then use the neighbor command
under the OSPF process. OSPF then uses unicast for OSPF connections.
Then you do not need broadcast capabilities on the FR interface to bring
up OSPF.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Ludwig Morales
Sent: 24. april 2002 13:43
To: chenyan
Cc: ccielab@groupstudy.com
Subject: Re: about ospf
If you use frame Relay Interface-dlci command on a multipoint interface
you'll loose the broadcast capability (use by OSPF to send hellos, LSA
etc)\
that you get when you use frame relay map ip x.x.x.x y broadcast
command, I
think one solution would be to use the frame relay network type
broadcast on
this interface.
Regards,
Ludwig
----- Original Message -----
From: "chenyan" <chenyan@deeptht.com.cn>
To: <ccielab@groupstudy.com>
Sent: Wednesday, April 24, 2002 5:41 AM
Subject: about ospf
> why can't the serial multipoint interface of FR send the ospf hello
packets FR, I use the framerelay interface-dlci XXX rather than the map?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:18 GMT-3