From: yakout esmat (yesmat@xxxxxxxxxxxxxx)
Date: Mon Apr 22 2002 - 07:44:43 GMT-3
Eric,
That might be a problem with your ISDN line or simulator if you are using
one. I had similar problem few days back. Just save your config and reboot
the dialing router and it should be fine.
HTH
Ya
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Eric Lamy
Sent: Monday, April 22, 2002 1:01 AM
To: ccielab@groupstudy.com
Subject: help needed on Dialer-watch.
Group,
I have a problem with dialer watch.
The router R2 detects the 15.1.1.0 route disparition but it never dials.
I put some debug : ip routing, dialer events and isdn q931.
If I ping 14.0.0.3. dialing occurs and ping is OK.
Any ideas on this?
Thanks
Eric LAMY
eric.lamy@wanadoo.fr
R2#sho run
Building configuration...
Current configuration : 1820 bytes
!
version 12.1
no service single-slot-reload-enable
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname R2
!
logging rate-limit console 10 except errors
!
username R3 password 0 cisco
ip subnet-zero
!
!
no ip finger
no ip domain-lookup
!
isdn switch-type basic-net3
call rsvp-sync
cns event-service server
!
!
!
!
!
!
!
!
interface Ethernet0/0
ip address 10.0.0.2 255.0.0.0
half-duplex
!
interface Serial0/0
no ip address
encapsulation frame-relay
!
interface Serial0/0.4 multipoint
ip address 13.0.0.2 255.0.0.0
frame-relay map ip 13.0.0.4 113 broadcast
!
interface TokenRing0/0
no ip address
ring-speed 16
!
interface BRI0/0
ip address 14.0.0.2 255.0.0.0
encapsulation ppp
dialer idle-timeout 60
dialer watch-disable 15
dialer map ip 15.1.1.0 name R3 broadcast 1008
dialer map ip 14.0.0.3 name R3 broadcast 1008
dialer watch-group 1
dialer-group 1
isdn switch-type basic-net3
ppp authentication chap
ppp multilink
!
interface Serial0/1
no ip address
shutdown
!
router eigrp 5
network 10.0.0.0
network 13.0.0.0
network 14.0.0.0
auto-summary
no eigrp log-neighbor-changes
!
ip kerberos source-interface any
ip classless
no ip http server
!
access-list 120 deny eigrp any any
access-list 120 permit ip any any
dialer watch-list 1 ip 15.1.1.0 255.255.255.0
dialer-list 1 protocol ip list 120
!
!
dial-peer cor custom
!
!
!
alias configure ae alias exec
alias exec i sho ip
alias exec ip sho ip protocols
alias exec ib sho ip int brie
alias exec ir sho ip route
alias exec e sho ip eigrp
alias exec o sho ip ospf
alias exec f sho ip frame
alias exec b sho ip bgp
alias exec r sho ip rip
alias exec g sho ip igrp
alias exec s sho run
alias exec c conf t
!
line con 0
transport input none
line aux 0
line vty 0 4
!
no scheduler allocate
end
R2#ir
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter
area
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is not set
C 10.0.0.0/8 is directly connected, Ethernet0/0
D 11.0.0.0/8 [90/2185984] via 13.0.0.4, 00:00:27, Serial0/0.4
C 13.0.0.0/8 is directly connected, Serial0/0.4
C 14.0.0.0/8 is directly connected, BRI0/0
15.0.0.0/24 is subnetted, 1 subnets
D 15.1.1.0 [90/2185984] via 13.0.0.4, 00:00:27, Serial0/0.4
R2#
R2#sho debug
Dial on demand:
Dial on demand events debugging is on
IP routing:
IP routing debugging is on
ISDN:
ISDN Q931 packets debugging is on
ISDN Q931 packets debug DSLs. (On/Off/No DSL:1/0/-)
DSL 0 --> 31
1 - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
R2#
R2#sho isdn act
----------------------------------------------------------------------------
-
---
ISDN ACTIVE CALLS
----------------------------------------------------------------------------
-
---
Call Calling Called Remote Seconds Seconds Seconds Charges
Type Number Number Name Used Left Idle
Units/Currency
----------------------------------------------------------------------------
-
---
----------------------------------------------------------------------------
-
---
R2#
4d02h: RT: delete route to 11.0.0.0 via 13.0.0.4, eigrp metric [90/2185984]
4d02h: RT: no routes to 11.0.0.0
4d02h: RT: delete route to 15.1.1.0 via 13.0.0.4, eigrp metric [90/2185984]
4d02h: RT: no routes to 15.1.1.0
4d02h: DDR: Dialer Watch: watch-group = 1
4d02h: DDR: network 15.1.1.0/255.255.255.0 DOWN,
4d02h: DDR: primary DOWN
4d02h: DDR: Dialer Watch: Dial Reason: Primary of group 1 DOWN
4d02h: DDR: Dialer Watch: watch-group = 1,
4d02h: RT: garbage collecting entry for 11.0.0.0
4d02h: RT: garbage collecting entry for 15.1.1.0
4d02h: DDR: Dialer Watch: watch-group = 1
4d02h: DDR: network 15.1.1.0/255.255.255.0 DOWN,
4d02h: DDR: primary DOWN
4d02h: DDR: Dialer Watch: Dial Reason: Primary of group 1 DOWN
4d02h: DDR: Dialer Watch: watch-group = 1,
4d02h: RT: delete network route to 15.0.0.0
R2#
R2#sho isdn act
----------------------------------------------------------------------------
-
---
ISDN ACTIVE CALLS
----------------------------------------------------------------------------
-
---
Call Calling Called Remote Seconds Seconds Seconds Charges
Type Number Number Name Used Left Idle
Units/Currency
----------------------------------------------------------------------------
-
---
----------------------------------------------------------------------------
-
---
R2#ir
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter
area
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is not set
C 10.0.0.0/8 is directly connected, Ethernet0/0
C 13.0.0.0/8 is directly connected, Serial0/0.4
C 14.0.0.0/8 is directly connected, BRI0/0
R2#
R2#
R2#sho version
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-JS-M), Version 12.1(5)T8, RELEASE SOFTWARE
(fc1)
TAC Support: http://www.cisco.com/cgi-bin/ibld/view.pl?i=support
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Mon 07-May-01 22:07 by ccai
Image text-base: 0x80008088, data-base: 0x813585F0
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
ROM: C2600 Software (C2600-JS-M), Version 12.1(5)T8, RELEASE SOFTWARE (fc1)
R2 uptime is 4 days, 2 hours, 48 minutes
System returned to ROM by power-on
System image file is "flash:c2600-js-mz.121-5.T8.bin"
cisco 2612 (MPC860) processor (revision 0x101) with 61440K/4096K bytes of
memory
.
Processor board ID JAD05220RL6 (2300065327)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
Basic Rate ISDN software, Version 1.1.
1 Ethernet/IEEE 802.3 interface(s)
1 Token Ring/IEEE 802.5 interface(s)
2 Serial(sync/async) network interface(s)
1 ISDN Basic Rate interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
R2#
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:16 GMT-3