From: Jason (jgraun@xxxxxxxxx)
Date: Sat Apr 20 2002 - 21:46:49 GMT-3
Get two laptops or whatever else you have that can run Win9x. Then
install NETBEUI on both boxes, and then connect them to the LAN
interfaces in which you have DLSW configured. You should be able to see
a circuit when you issue the show dlsw circuits command. Also you
should be able to see the other machine in network neighborhood, however
I have done a lot of testing this with and sometimes you want be able to
see which other in network neighborhood but the routers will show the
resolved names and circuits.
Jason
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Steven Owen
Sent: Saturday, April 20, 2002 2:32 AM
To: ccielab
Subject: how to confirm the dlsw result?
now i am learinging dlsw .
I just use virtual tokenring interface.
after i finished the config.
how could i test the result?
the peer connection is up.
and i can ping successfully from a ethernet int
to a virtual int,
but without any dlsw config,you also can ping it.
Cause in order to construct dlsw peer ,you have to use
routing protoc or defult route to make peer know each other.
Do i have to use a pc with a tokenring card?
Thanks.
|:"f
|g-J
+~7&!"\"fv7,1+a6Zy
_rj(}J&
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:14 GMT-3