From: Lupi, Guy (Guy.Lupi@xxxxxxxxxxxxx)
Date: Fri Apr 19 2002 - 16:31:49 GMT-3
Just out of curiousity, when would you use the dialer map llc2 command?
When you are doing direct encapsulation on the ISDN interface with pass
thru?
~-----Original Message-----
~From: DAN DORTON [mailto:DHSTS68@dhs.state.il.us]
~Sent: Friday, April 19, 2002 3:13 PM
~To: ccielab@groupstudy.com; percy_gunner@hotmail.com;
~babacard2000@yahoo.com
~Subject: Re: DLSw+ & DDR
~
~
~dialer maps too
~
~If you are using tcp you need to map ip layer 3 to layer 2.
~
~>>> "Perminder Grewal" <percy_gunner@hotmail.com> 04/19/02 12:52PM >>>
~Your 'dialer-list 1 protocol llc2 permit' seems to be wrong,
~you should
~define ip as your interesting traffic. The LLC2 is wrong, the
~dlsw uses TCP
~as the encapsulated protocol running over IP. DlSW terminates the LLC2
~locally.
~
~Regards
~
~Percy
~
~
~>From: Babacar Diop <babacard2000@yahoo.com>
~>Reply-To: Babacar Diop <babacard2000@yahoo.com>
~>To: cciegroup <ccielab@groupstudy.com>
~>Subject: DLSw+ & DDR
~>Date: Fri, 19 Apr 2002 10:23:49 -0700 (PDT)
~>
~>Here is my config on two routers. When i pull the
~>serial interface cable of R5, the isdn circuit does
~>not come up. I am doing anything wrong?
~>
~>
~>For R5
~>
~>username r3 password 0 cisco
~>!
~>isdn switch-type basic-ni
~>!
~>!
~>!
~>!
~>source-bridge ring-group 100
~>dlsw local-peer peer-id 133.14.55.1 promiscuous
~>dlsw remote-peer 0 tcp 133.14.23.6
~>dlsw remote-peer 0 tcp 133.14.23.3 backup-peer
~>133.14.23.6
~>!
~>interface Loopback0
~> ip address 133.14.5.5 255.255.255.0
~> ip ospf network point-to-point
~>!
~>interface Serial0
~> backup delay 10 200
~> backup interface BRI0
~> no ip address
~> encapsulation frame-relay
~> frame-relay lmi-type ansi
~>!
~>interface Serial0.1 point-to-point
~> ip address 133.14.56.5 255.255.255.0
~> frame-relay interface-dlci 506
~>!
~>interface Serial0.2 multipoint
~> ip address 133.14.243.5 255.255.255.0
~> no ip split-horizon
~> ip ospf priority 100
~> frame-relay interface-dlci 503
~> frame-relay interface-dlci 504
~>!
~>interface TokenRing0
~> ip address 133.14.55.1 255.255.255.248
~> ring-speed 16
~> source-bridge 10 1 100
~>!
~>interface BRI0
~> ip address 133.14.35.5 255.255.255.252
~> encapsulation ppp
~> dialer idle-timeout 10
~> dialer map llc2 name r3 broadcast 8358664
~> dialer load-threshold 1 either
~> dialer-group 1
~> isdn switch-type basic-ni
~> isdn spid1 0835866101 8358661
~> isdn spid2 0835866301 8358663
~> ppp authentication chap
~> ppp multilink
~>!
~>router ospf 64
~> log-adjacency-changes
~> area 3 range 133.14.51.0 255.255.255.0
~> area 3 virtual-link 200.200.200.1
~> network 133.14.5.0 0.0.0.255 area 0
~> network 133.14.35.4 0.0.0.3 area 3
~> network 133.14.51.0 0.0.0.15 area 3
~> network 133.14.55.0 0.0.0.7 area 0
~> network 133.14.56.0 0.0.0.255 area 0
~> network 133.14.243.0 0.0.0.255 area 0
~> neighbor 133.14.243.4
~> neighbor 133.14.243.3
~>!
~>ip classless
~>ip http server
~>!
~>dialer-list 1 protocol llc2 permit
~>
~>For R3:
~>
~>hostname r3
~>!
~>!
~>username r5 password 0 cisco
~>!
~>!
~>!
~>!
~>ip subnet-zero
~>no ip domain-lookup
~>!
~>isdn switch-type basic-ni
~>!
~>!
~>!
~>!
~>dlsw local-peer peer-id 133.14.23.3 promiscuous
~>dlsw remote-peer 0 tcp 133.14.23.6
~>dlsw bridge-group 1
~>!
~>interface Loopback0
~> ip address 133.14.3.3 255.255.255.0
~> ip ospf network point-to-point
~>!
~>interface Ethernet0
~> ip address 133.14.23.3 255.255.255.0
~> bridge-group 1
~>!
~>interface Serial0
~> no ip address
~> encapsulation frame-relay
~> no fair-queue
~> frame-relay lmi-type ansi
~>!
~>interface Serial0.1 multipoint
~> ip address 133.14.243.3 255.255.255.0
~> ip ospf priority 0
~> frame-relay interface-dlci 305
~>!
~>!
~>interface BRI0
~> ip address 133.14.35.6 255.255.255.252
~> encapsulation ppp
~> dialer idle-timeout 10
~> dialer map llc2 name r5 broadcast
~> dialer load-threshold 1 either
~> dialer-group 1
~> isdn switch-type basic-ni
~> isdn spid1 0835866201 8358662
~> isdn spid2 0835866401 8358664
~> ppp authentication chap
~> ppp multilink
~>!
~>router ospf 64
~> log-adjacency-changes
~> network 133.14.35.4 0.0.0.3 area 3
~> network 133.14.243.0 0.0.0.255 area 0
~> distribute-list 1 out igrp 64
~>!
~>ip classless
~>ip http server
~>!
~>dialer-list 1 protocol llc2 permit
~>!
~>
~>Thanks for your help.
~>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:13 GMT-3