From: Christopher Jarosz (cajarosz@xxxxxxxxx)
Date: Tue Apr 16 2002 - 14:22:52 GMT-3
Hi !!
You need to go into configuration mode, type in the command and exit. after
you write the config, the new commands should appear when you type in a "?"
best regards !!!
chrisj
----- Original Message -----
From: "Huy Luu" <hluu@veroxity.com>
To: "Christopher Jarosz" <cajarosz@attbi.com>
Cc: <ccielab@groupstudy.com>
Sent: Tuesday, April 16, 2002 7:17 AM
Subject: Re: Engineering mode
>
> Thankyou Chris,
>
> I don't really see a difference when typing this command. The command
> prompt stays the same and the availabe commands in config mode stays the
> same, except for the command coverage? Is tis all , or am I missing
> something?
>
> Huy Duc Luu
> Principal Consultant
> Veroxity Technology Partners
> Fax 617-779-3099
> Cell# (617) 293-0940
> Email: hluu@veroxity.com
>
>
>
>
> "Christopher
> Jarosz" To: "Huy Luu"
<hluu@veroxity.com>, "Manny Gonzalez" <gonzalu@nyp.org>
> <cajarosz@attb cc: <ccielab@groupstudy.com>
> i.com> Subject: Re: Engineering mode
>
> 04/15/02 12:54
> AM
>
>
>
>
>
>
> Hi !!!
>
> Try "service internal". This will give you access to the stuff the tac
> uses.......
>
> chrisj
>
> ----- Original Message -----
> From: "Huy Luu" <hluu@veroxity.com>
> To: "Manny Gonzalez" <gonzalu@nyp.org>
> Cc: <ccielab@groupstudy.com>
> Sent: Friday, April 12, 2002 12:26 PM
> Subject: Engineering mode
>
>
> > Is there a way to access engineer mode on the router and/or IOS based
> > catalyst?
> >
> > Thanks.
> >
> >
> >
> >
> > "Manny
> > Gonzalez" To: Manny Gonzalez
> <gonzalu@nyp.org>
> > <gonzalu@nyp.o cc: Timothy Ouellette
> <timoue@cogeco.ca>, cisco@groupstudy.com,
> > rg> ccielab@groupstudy.com
> > Sent by: Subject: Re: Change the
> Bridge ID on a cat5k
> > nobody@groupst
> > udy.com
> >
> >
> > 04/11/02 04:05
> > PM
> > Please respond
> > to "Manny
> > Gonzalez"
> >
> >
> >
> >
> >
> >
> > Okay, here is a link to instructions on how to get into Engineering
Mode.
> I
> > am banging away at it
> > figuring out how to do it. If someone finds out first, please post your
> > findings :-)))
> >
> > http://www.heinzulm.com/Cat1.htm
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:10 GMT-3