DLSW basic question !!

From: Jeongwoo Park (jpark@xxxxxxxx)
Date: Thu Apr 11 2002 - 17:40:53 GMT-3

• Next message: Jeff Duchin: "RE: spanning tree"
• Previous message: Jeongwoo Park: "RE: DLSW direct encaps"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
I am confused with basic config.
When you guys were talking about "direct encap" what is the command for it?
Is it Dlsw remote-peer 0 frame-relay interface serial 0 100
Or
Dlsw remote-peer 0 interface serial 0 100 *****( without "frame-relay" )
Are these same?

I am asking this because I see this when I configure;
Salinas_New(config)#dlsw remote-peer 0 ?
  frame-relay Use Frame Relay for remote peer transport
  fst Use fast sequence transport (FST) for remote peer transport
  interface Use a direct interface for remote peer transport
  tcp Use TCP for remote peer transport

Thanks in adv.

• Next message: Jeff Duchin: "RE: spanning tree"
• Previous message: Jeongwoo Park: "RE: DLSW direct encaps"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:05 GMT-3