From: Gregg Malcolm (greggm@xxxxxxxxxxxxx)
Date: Thu Apr 11 2002 - 12:57:43 GMT-3
Glenn,
Have you thought of using 2 tunnels? Use IP source and dest of your frame
map statements. Then put the 12 and 23 nets on the tunnels. I believe it
will work.
It's also a way to fix IPX rip split horizon issues.
HTH, Gregg
----- Original Message -----
From: "Williams, Glenn" <WILLIAMSG@PANASONIC.COM>
To: <ccielab@groupstudy.com>
Sent: Thursday, April 11, 2002 7:37 AM
Subject: Duplicate DLCIs
> Want to know if this can be done.
>
> R1 ---(F/R)-----R2 -------(F/R)-------R3
>
> R2 is hub. I want point to multipoint for a IPX network. All frame
> connections using same IPX network, say IPX network 123. But I also want
> two individual point-to-point IP networks. We will say 12.0.0.0 network
> from R1 to R2 and 23.0.0.0 from R2 to R3.
>
> I can not create the DLCIs to do this because I get an error that says
DLCI
> already exists when I have already mapped it for IPX and want to map it
> again under new sub interface for IP. I tried putting a secondary IP
> address under the multipoint, but doesn't ping too well.
>
>
> Any ideas or won't this work? Obviously there is something I don't
> understand about frame relay.
>
> GW
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:05 GMT-3