From: MADMAN (dave@xxxxxxxxxxxxxx)
Date: Sun Apr 07 2002 - 18:00:41 GMT-3
Keep in mind this only applies to multipoint interfaces.
Dave
Andri Bersvendsen wrote:
> Hi Bill,
>
> It is by default not possible to ping local Frame-Relay (or ATM)
> interface on a Cisco router. To do this you MUST have a 'frame-relay
> map' with the local IP address pointing to one of the DLCI's you have.
> The other end of the PVC must have a map back to your interface.
>
> With this configuration you can ping your local interface. But the
> packet is transmitted over FR and returned before the ping request is
> reaching the local interface.
>
> Remember that you no longer have inverse arp when you have configured
> one 'frame-relay map'. So if you use map on a interface for one
> destination you must use map's for the other destinations on the same
> interface.
>
> Regards,
> Andri Bersvendsen
>
> -----Original Message-----
> From: Bill Mckenzie
> To: ccielab@groupstudy.com
> Sent: 06.04.2002 21:12
> Subject: PVC-Active Not able to ping
>
> I'm configuring frame relay and the pvc's show active , but I'm not able
> to
> ping any directly connected interface.
>
> Any help?
>
> Thanks
> Bill
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:59 GMT-3