From: George Stylianou (georges@xxxxxxxx)
Date: Tue Apr 02 2002 - 14:09:58 GMT-3
hi all,
anyone know if this is possible?
thanks
George
----- Forwarded message from "Marcelo M. Sosa Lugones" <marcelo@sosa.com.ar>
-----
From: "Marcelo M. Sosa Lugones" <marcelo@sosa.com.ar>
To: <cisco-nsp@puck.nether.net>
Subject: setting the source of an icmp error
Date: Fri, 29 Mar 2002 21:59:51 -0300
Resent-From: cisco-nsp@puck.nether.net
Hello,
Is it possible to define the source address of an icmp error in Cisco
routers?
I have some point-to-point links with rfc1918 address and i want to
configure them so they have at least a loopback address with global ip
address and any icmp that should be sent from that router use the ip address
global, not the one of the right interface. I'm looking for something like
"ip icmp unreachable source loopback0", but it doesn't exists :)
Thanks,
Marcelo.
"This e-mail may contain confidential information and may be legally
privileged and is intended only for the person to whom it is addressed. If
you are not the intended recipient, you are notified that you may not use,
distribute or copy this document in any manner whatsoever. Kindly also
notify the sender immediately by telephone, and delete the e-mail. When
addressed to clients of the company from where this e-mail originates ("the
sending company ") any opinion or advice contained in this e-mail is subject
to the terms and conditions expressed in any applicable terms of business or
client engagement letter . The sending company does not accept liability for
any damage, loss or expense arising from this e-mail and/or from the
accessing of any files attached to this e-mail."
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:51 GMT-3