From: BEDA jain (bedup@xxxxxxxxxxx)
Date: Mon Apr 01 2002 - 00:59:10 GMT-3
when you don't use ppp encaptulation both of your like will be up for single
call.
when you use ppp, only link will be up for single call
>From: "Ronny Jonathan" <rjonathan@yahoo.com>
>Reply-To: "Ronny Jonathan" <rjonathan@yahoo.com>
>To: <ccielab@groupstudy.com>
>Subject: Re: ISDN question
>Date: Mon, 1 Apr 2002 00:06:20 +0800
>
>Have you tried to put ppp parameters like authentication, multilink, etc ?
>Is it working also ?
>
>Regards,
>Ronny
>
>----- Original Message -----
>From: "Lupi, Guy" <Guy.Lupi@eurekaggn.com>
>To: "'Ronny Jonathan'" <rjonathan@yahoo.com>; <ccielab@groupstudy.com>
>Sent: Sunday, March 31, 2002 11:03 PM
>Subject: RE: ISDN question
>
>
> > I see your logic, but I have never had to use the encapsulation ppp
>command
> > on the bri interface regardless of whether it was for inbound or
>outbound
> > calls. I am in the lab right now and I have it set up, it is working
>fine
> > without the encapsulation on the physical interface. The bri interface
> > shows hdlc encapsulation, but the b channels and dialer interface show
>ppp.
> > I also have a host route on both the incoming and outgoing routers,
>which
> > would indicate to me that they are actually running ppp.
> >
> >
> > ~-----Original Message-----
> > ~From: Ronny Jonathan [mailto:rjonathan@yahoo.com]
> > ~Sent: Sunday, March 31, 2002 9:42 AM
> > ~To: ccielab@groupstudy.com
> > ~Subject: Re: ISDN question
> > ~
> > ~
> > ~The ppp encap on the BRI (physical interface) is needed when
> > ~the your dialer interface was configured for incoming call.
> > ~
> > ~When there is an incoming call, the physical interface will receive
> > ~the call before the call can be associated with the dialer interface.
> > ~
> > ~If your dialer interfaces were only for outgoing calls, you need not
> > ~configured ppp encap on the physical (BRI) interface.
> > ~
> > ~Regards,
> > ~Ronny
> > ~----- Original Message -----
> > ~From: "Lupi, Guy" <Guy.Lupi@eurekaggn.com>
> > ~To: <ccielab@groupstudy.com>
> > ~Sent: Sunday, March 31, 2002 8:53 PM
> > ~Subject: ISDN question
> > ~
> > ~
> > ~> I have noticed in certain sample configs on CCO that when
> > ~using dialer
> > ~> interfaces, ppp encapsulation is specified on both the BRI and on the
> > ~dialer
> > ~> interface. I have found that I don't need to have it on the BRI
> > ~interface,
> > ~> at least not in any of the configs that I have done. Does
> > ~anyone know if
> > ~it
> > ~> is required to have the ppp encap specified on the BRI in certain
> > ~situations
> > ~> when using dialer interfaces? Thanks.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:27 GMT-3