Snapshot

From: Tarek Sabry (tsabry@xxxxxxxxxxxxxxxxxxx)
Date: Fri Mar 29 2002 - 14:52:33 GMT-3

• Next message: John Elias: "Re: Route Reflector and Sync"
• Previous message: steven.j.nelson@xxxxxx: "Route Reflector and Peer Group"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Simple snapshot questions:

1- Can you explain the "dialer" optional keyword please? I can't understand
it from Caslow :(
2- How can you explain the following output? I'm totally confused. BRI0 is
up, line protocol is up, while Snapshot client is down. And there are ZERO
active calls!

r5#
r5#sh snap
BRI0 is up, line protocol is upSnapshot client line state down
  Length of active period: 5 minutes
  Length of quiet period: 8 minutes
  Length of retry period: 8 minutes
    Current state: active, remaining/exchange time: 1/0 minutes
r5#
r5#
r5#
r5#
r5#
r5#sh isdn sta
Global ISDN Switchtype = basic-net3
ISDN BRI0 interface
        dsl 0, interface ISDN Switchtype = basic-net3
    Layer 1 Status:
        ACTIVE
    Layer 2 Status:
        TEI = 89, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
    Layer 3 Status:
        0 Active Layer 3 Call(s)
    Active dsl 0 CCBs = 0
    The Free Channel Mask: 0x80000003
    Number of L2 Discards = 0, L2 Session ID = 21
    Total Allocated ISDN CCBs = 0
r5#

Thanks
Tarek

• Next message: John Elias: "Re: Route Reflector and Sync"
• Previous message: steven.j.nelson@xxxxxx: "Route Reflector and Peer Group"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:25 GMT-3