From: Ahmed Mamoor Amimi (mamoor@xxxxxxxx)
Date: Thu Mar 28 2002 - 21:02:43 GMT-3
timer basic 5 10 10 10
done this many time...
-Mamoor
----- Original Message -----
From: Muhamamd Durrani <dan_schaw@yahoo.com>
To: Nicolai Gersbo Solling <nicolai@cisco.com>; CCIE
<ccielab@groupstudy.com>
Sent: Thursday, March 28, 2002 8:01 AM
Subject: Re: Tuning IGRP timers IGRP
> Is there any GraceFull restart process for IGRP as we
> have for OSPF !!!!
> Let me check RFC and will get back to you !
>
> Regards,
>
>
> --- Nicolai Gersbo Solling <nicolai@cisco.com> wrote:
> > Hi there gang...
> >
> > I have this scenario:
> >
> > R1---ETH---R2
> > Backup interface is ISDN...
> >
> > I am running IGRP between R1 and R2...
> > The thing I wan't to do is to tune the IGRP process
> > so that it does not take
> > more then 5 seconds from when the primary link goes
> > down untill the routing
> > table is complete again...
> >
> > I know I need to do this with the timers basic
> > command under the IGRP
> > process, but I am doubtfull on what to set them
> > to...
> >
> > The obvious would ofcourse be:
> >
> > update interval: 5 sec.
> > Invalid: 15
> > holdown: 15
> > and flush: 45
> >
> > But...will this not mean that I will be clogging up
> > the link with updates?
> >
> > Is there a more elegant way of doing it?
> >
> >
> >
> > Nic
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:24 GMT-3