From: kurt kruegel (kurt@xxxxxxxxxxxx)
Date: Mon Mar 18 2002 - 13:07:19 GMT-3
i aggree i tried this on a 2600 and could not find clockrate
Jon.Maiman@inrange.com wrote:
> Hi Dan,
>
> I have found it depends on the interface hardware. I can see the
> clockrate via the "show controller" command when the hardware is a nm-4t
> or a PA-8T. Both the WIC-1T and WIC-2T don't appear to support this
> feature. Not sure if it is a hw limitation or a driver issue Cisco will
> eventually get around to upgrading. Hope this helps...
>
> --Jon
>
> "DAN DORTON" <DHSTS68@dhs.state.il.us>
> Sent by: nobody@groupstudy.com
> 03/18/02 09:22 AM
> Please respond to "DAN DORTON"
>
>
> To: <mflint@famvid.com>, <ben@kesslerconsulting.com>
> cc: <ccielab@groupstudy.com>, <jytszeto@hotmail.com>
> Subject: Re: Find the clock rate??
>
> I can't see it either, on my 2500s, 2600s, 1600s, or 3640s.
>
> I am running various codes ranging from 11.3 to 12.2.
>
> >>> Maurice Flint <mflint@famvid.com> 03/17/02 12:42PM >>>
> I have C2600's and do not see the clock rate you mentioned. Is there a
> way to
> determine the clock rate from the DCE device on a local DTE interface?
>
> Thanks for your help.
>
> "R. Benjamin Kessler" wrote:
>
> > show controllers serial 0
> >
> > ~10 lines down from the top there will be a line that indicates the
> > "received clockrate"
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> > hSzeto Jeff
> > Sent: Friday, March 15, 2002 6:57 AM
> > To: ccielab@groupstudy.com
> > Subject: Find the clock rate??
> >
> > Hi,
> >
> > My question may be elementary, but please help.
> >
> > If I can only access the DTE side,
> > how can I find the clock rate of the DCE side ?
> >
> > I have tried to debug, the response follows
> >
> > R3#debug int s0
> > Condition 1 set
> >
> > What is the meaning of that response?
> >
> > Thank you in advance.
> >
> > Jeff
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:12 GMT-3