From: Chua, Parry (Parry.Chua@xxxxxxxxxx)
Date: Sun Mar 17 2002 - 21:55:23 GMT-3
Hi,
It this you are loking for, direct from doc cdrom :
explorer-delay-time
==================
Time to wait before sending or accepting explorers.
The valid range is 1 to 5 minutes. The default is 0.
sna-explorer-timeout
=================
Length of time that the Cisco IOS software waits for an explorer response befor
e marking a resource unreachable (on a LAN and WAN).
The valid range is 1 to 86400 seconds. The default is 180 seconds (3 minutes).
explorer-wait-time
===============
Time to wait for all stations to respond to explorers.
The valid range is 1 to 86400 seconds. The default is 0.
Parry Chua
-----Original Message-----
From: Ahmed Mamoor Amimi [mailto:mamoor@ieee.org]
Sent: Saturday, March 16, 2002 11:38 AM
To: Narvaez, Pablo; Williams, Glenn; sandyccie@yahoo.com;
ccielab@groupstudy.com
Subject: Re: DLSW Cost command
i dont think there is a wait time..... as soon asdlsw router gets a switch
it began forwading. but we can influnce it with this command
-Mamoor
----- Original Message -----
From: Narvaez, Pablo <Pablo.Narvaez@getronics.com>
To: Ahmed Mamoor Amimi <mamoor@ieee.org>; Williams, Glenn
<WILLIAMSG@PANASONIC.COM>; <sandyccie@yahoo.com>; <ccielab@groupstudy.com>
Sent: Saturday, March 16, 2002 4:51 AM
Subject: RE: DLSW Cost command
> Does anyone know what is the default timer explorer-wait-time for dlsw?
>
> Thanks.
>
> -hockito-
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:11 GMT-3