From: Mannan Venkatesan (mv70@xxxxxxxxxx)
Date: Mon Mar 11 2002 - 11:36:35 GMT-3
Bajaj,
Yigit is correct. "out" option works differently when you use it with a RP.
If you use it with interface, it will filter the routes sending out of that
interface.
It you use it with RP, it will filter the routes from the RP being
redistributed.
HTHs,
Mannan
----- Original Message -----
From: "A Yigit Zorlu" <alec_cisco@yahoo.com>
To: "'Bhisham Bajaj'" <bhishambajaj@yahoo.com>; "'Mannan Venkatesan'"
<mv_lab@hotmail.com>; "'lab'" <ccielab@groupstudy.com>
Sent: Monday, March 11, 2002 1:48 AM
Subject: RE: distribute-list
> Hi,
>
> If you would using distribute-list 1 out serial 0 you were correct. But in
> this case it filters routes coming out of EIGRP into OSPF. Same for
> connected. Same for IPX as well
>
> ipx nlsp
> redistribute eigrp 1
> distribute-list 7 out eigrp 1
> from EIGRP into NLSP.
>
> Thanks,
>
> Yigit
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Bhisham Bajaj
> Sent: Monday, March 11, 2002 6:32 AM
> To: Mannan Venkatesan; lab
> Subject: Re: distribute-list
>
>
> Mannan
> i am trying to use a distribution list with the out
> key word
> i thought that if i was using it with the in key word
> then it would filter incomming routes that i get into
> the ospf process by the redistribute command & also as
> ospf is a link state protocol we will have the route
> in the datbase but not in the routing table
>
> but i am try to use the distribution list out so it
> should filer routes that are going out of the ospf
> process to other routing process
>
> Bajaj
> --- Mannan Venkatesan <mv_lab@hotmail.com> wrote:
> > Nope. The other way around.
> >
> > First statement is to filter routes from eigrp 1 to
> > ospf based on acl 1.
> >
> > Second is to filter routes from connected to ospf
> > based on acl 1.
> >
> > Mannan
> >
> > ----- Original Message -----
> > From: "Bhisham Bajaj" <bhishambajaj@yahoo.com>
> > To: <ccielab@groupstudy.com>
> > Sent: Sunday, March 10, 2002 9:42 PM
> > Subject: distribute-list
> >
> >
> > > router ospf 1
> > > distribute-list 1 out eigrp 1
> > >
> > > this will fliter routes baed on access-list 1 when
> >
> > > redistributing ospf routes into eigrp 1
> > >
> > > but what does this command do
> > >
> > >
> > > router ospf 1
> > > distribute-list 1 out connected
> > >
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:00 GMT-3