From: Cassidy D. Smith (csmith@xxxxxxxxxxxxxxxxxxxxx)
Date: Fri Mar 08 2002 - 09:31:06 GMT-3
Yigit, you probably have an emulation problem, it is not telling the
router what its number of lines (and possibly columns) is. You can see
what it is configured for with " show terminal" you can set the lines
with the command "Terminal Length 25" where 25 is the number of
lines, this is done at the normal enable prompt not in config mode. I
like to set it to 500 when I am going to capture the config and I don't
wan't those nasty "More" lines messing up the config, I then change it
back..
Cassidy...
A Yigit Zorlu wrote:
>Hi all,
>
>when i type sh run on the router, all the config flows on the screen then I
>reach the exec prompt. I do not see any --------- more -------- statement
>which enables me to see the config page by page. Is there any command that
>makes my router behaves like this or is this because of the terminal
>emulation program...
>
>Regards,
>
>Yigit
>
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:56 GMT-3