From: Narvaez, Pablo (Pablo.Narvaez@xxxxxxxxxxxxx)
Date: Thu Mar 07 2002 - 21:00:18 GMT-3
Change the configuration register value to have the router boot from BOOT ... i
n this mode, the flash becomes Read/Write.
You can use the conf reg value 0x1.
router(config)# config-register 0x1
router# reload
router<(boot)># sh ver
.
.
.
16384K bytes of processor board System flash (Read/Write)
Upgrade the router, change back the conf reg value to 0x2102, reload the router
and that's it.
Cheers,
hockito
-----Original Message-----
From: Ludwig Morales [mailto:morales_l@hotmail.com]
Sent: Jueves, 07 de Marzo de 2002 05:38 p.m.
To: ccielab@groupstudy.com
Subject: read only Flash
Pie Chartshi everybody,
one of my routers flash states to be "read only" how do i change this so
that i can erase it and load another IOS
cisco 2500 (68030) processor (revision L) with 14336K/2048K bytes of memory.
Processor board ID 08319120, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
1 Token Ring/IEEE 802.5 interface(s)
2 Serial network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read ONLY)
Configuration register is 0x2102
regards,
Ludwig
[GroupStudy.com removed an attachment of type text/x-vcard which had a name of
Ludwig A. Morales.vcf]
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:56 GMT-3