From: Bob Sinclair (bsin@xxxxxxxxx)
Date: Wed Mar 06 2002 - 14:02:45 GMT-3
----- Original Message -----
From: "Bob Sinclair" <bsin@erols.com>
To: "DAN DORTON" <DHSTS68@dhs.state.il.us>
Sent: Wednesday, March 06, 2002 11:46 AM
Subject: Re: csim start
Dan,
Thanks for the input. Good to know others have seen this, too. Could be an IO
S thang. Debug of vofr-errors below. Says "no xmit function" (whatever that
means). But phone seems to work.
r7#debug ccswvoice vofr-errors
CCSWVOICE Vofr Error tracing is enabled
r7#csim start 2222
csim: called number = 2222, loop count = 1 ping count = 0
*Feb 28 23:47:24: ccswvofr_pkt_handler: no xmit function for callID 62 dlci 702
cid 17
csim: loop = 1, failed = 1
csim: call attempted = 1, setup failed = 1, tone failed = 0
r7#
----- Original Message -----
From: "DAN DORTON" <DHSTS68@dhs.state.il.us>
To: <bsin@erols.com>
Sent: Wednesday, March 06, 2002 11:44 AM
Subject: Re: csim start
Just an FYI...
I get this same error sometimes using it even when I KNOW it is working.
I actually have phones connected & can make & receive calls.
When I use that command it will even make the phone ring that I am calling, but
it still comes back with a fail message.
>>> "Bob Sinclair" <bsin@erols.com> 03/06/02 10:08AM >>>
Chad,
Output from csim start is below. I can call and ring 7777 from the phone, but
csim start seems to be saying the test fails:
r2#csim start 7777
csim: called number = 7777, loop count = 1 ping count = 0
csim: loop = 1, failed = 1
csim: call attempted = 1, setup failed = 1, tone failed = 0
Thanks!
----- Original Message -----
From: "Simmons, Chad A" <chad_a_simmons@groton.pfizer.com>
To: "'Bob Sinclair'" <bsin@erols.com>; <ccielab@groupstudy.com>
Sent: Wednesday, March 06, 2002 11:05 AM
Subject: RE: csim start
> What error are you getting?
>
> Chad A. Simmons
> MCSE, CCNP, CCDP, CCIE Lab Candidate
> Network Engineering and Capacity Planning
> Pfizer PGRD CIT-Groton
> Senior Network Consultant
> (860)715-5307
>
>
> -----Original Message-----
> From: Bob Sinclair [mailto:bsin@erols.com]
> Sent: Wednesday, March 06, 2002 10:20 AM
> To: ccielab@groupstudy.com
> Subject: csim start
>
>
> I am doing some voice practice on Bradshaw labs. Testing voice by reverse
> telnet to modem, then atdt command allows you to see the ring telneted into
> the modem on the other end.
>
> However, testing using "csim start <number> fails.
>
> Any idea why? I get zero hits on CCO for this command.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:55 GMT-3