From: RSiddappa@xxxxxxxxxx
Date: Wed Mar 06 2002 - 07:40:44 GMT-3
There are two authntication methods.
1. Per area Authnetication - all the routers ( All the interfaces of
routers in that area) needs to be enabled for authntication.
2. Per Interafce Authnetication - When u need authntication between only
two or more interfaces but do nto need the authntication for the entire
area.
Commands :
IP OSPF Authntication - This will enable the interafce specific
authntication.
( U do not need this command if u are using the uthntication for the
whole area ).
IP OSPF authentication-key and IP ospf message-digest-key 1 md5 -
these commands are used to set u r password.
area 0 authntication - enables authntication for the entire area.
Make sure what ur using.
Rajeev.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:54 GMT-3