From: Curtis Phillips (cphillips@xxxxxxxxxxxx)
Date: Tue Mar 05 2002 - 13:50:05 GMT-3
Have you tried a different cable?
----- Original Message -----
From: "Craig Columbus" <Craig.Columbus@columbusconsulting.com>
To: <cisco@groupstudy.com>
Cc: <ccielab@groupstudy.com>
Sent: Tuesday, March 05, 2002 11:18 AM
Subject: Stupid 2500 confreg question
> Has anyone run into an issue where a 2500 series router won't respond to
> console input?
> Here's the deal:
> The PC is running 9600-8-N-1 and is connected to the 2500 console port.
> The router has had nvram erased and is being booted for the first time.
> Upon boot, the normal boot process is seen on the monitor screen.
> When prompted to enter configuration dialogue, it's not possible to input
> anything on the router. Typing does nothing and there is no response from
> the router.
> If Ctrl-F6-Break is pressed during boot, the router goes to the > prompt,
> but after that, the router still won't accept any input from the console
port.
>
> Has anyone experienced this issue? Is this a config register problem? If
> so, is there a fix other than experimenting with different settings on the
> PC side? If not, does anyone have an answer? Could it be bad boot ROM?
>
> Thanks,
> Craig
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:53 GMT-3