From: Jim Newton (jnewton@xxxxxxxxxxxxxxx)
Date: Tue Mar 05 2002 - 12:27:05 GMT-3
Also, this is kind of a trick question in this case, because the serial line
is configured to carry 250K of traffic. So if you configure the ISDN line to
use both channels, you get 250K on the serial and 128K on the ISDN, so you
have one third of the traffic on the ISDN circuit.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of Nick
Shah
Sent: Tuesday, March 05, 2002 4:15 AM
To: Alex Hsieh; ccielab@groupstudy.com
Subject: Re: isdn backup
backup load
depending on the routing protocol you may need to configure the extra bit to
carry 1/3 of traffic (i havent seen this lab, but the command mentioned
above should help u start)
hth
Nick
----- Original Message -----
From: "Alex Hsieh" <ccie21@hotmail.com>
To: <ccielab@groupstudy.com>
Sent: Tuesday, March 05, 2002 6:04 PM
Subject: isdn backup
> I am doing fatkid lab 505,on isdn section,it states "The dial-up line
> between R2 and R3 should also be brought up if the serial line between R3
> and R5 exceeds 50% utilization. In this case the line should handle 1/3
of
> the traffic from R3"
>
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> Whats the command used to configure this task?I cant seem to find answer
on
> solution page.Thanks.
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:53 GMT-3