From: Williams, Glenn (WILLIAMSG@xxxxxxxxxxxxx)
Date: Tue Feb 19 2002 - 15:08:35 GMT-3
is this using the dlsw timer command? If so, which option?
GW
-----Original Message-----
From: Sandro Ciffali [mailto:sandyccie@yahoo.com]
Sent: Tuesday, February 19, 2002 12:05 PM
To: Williams, Glenn; 'ccielab@groupstudy.com'
Subject: Re: DLSW Cost command
With the cost it is very important to set the dlsw
timers to a large value, DLSW does not care for the
cost if it recd. the reply from a higher cost peer
first...If you increase the timer it will wait for
both the replies and then would go with a lower cost
peer.
Sandro
--- "Williams, Glenn" <WILLIAMSG@PANASONIC.COM> wrote:
> Hi,
>
> Can't seem to get the cost command to work. I have
> two spokes at the other
> end of a frame hub. Both spokes have their Ethernet
> ports tied together.
> Both spokes are DLSW remote peers to the hub and in
> promiscuous mode. I can
> set the cost to them from the hub or from them to
> the hub in order to get to
> their shared Ethernet vlan. But never can I seem to
> control which remote
> peer the hub chooses.
>
> First is the lower cost of 1 verses 5 supposed to be
> preferred in dlsw?
> Second, any ideas what is missing?
>
> TIA
> GW
>
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:27 GMT-3