Re: problem between ISL and RIP,IGRP with config(again)

From: sherry huies (cholscurry@xxxxxxxxxxx)
Date: Mon Feb 11 2002 - 12:37:19 GMT-3

• Next message: Jason Graun: "Dlsw Bridge Group between two Ethernet interfaces"
• Previous message: Li Wenhui: "Re: problem between ISL and RIP,IGRP with config(again)"
• Maybe in reply to: sherry huies: "problem between ISL and RIP,IGRP with config(again)"
• Next in thread: Li Wenhui: "Re: problem between ISL and RIP,IGRP with config(again)"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
hi all,

of courese, in Fastethernet, split-horizon enable.
also,i suppose to be catalyst switch has some problem.
but after i verify the catalyst switch 5505's
configuration(WS-C5505 Version McpSW: 4.5(12))
i can't understand why this problem arise to.
there is no problem in switch.

R5's fastethernet is connected to port 5 (vlan 10)
R6's fastethernet is connected to port 6
(ISL Trunk port)

R5's ping test to R6's Fastethernet0/1.10 is good.
also, R6's ping test to R5's Fastethernt0/0 is good.

Thanks and Best regards
sherry

--- Li Wenhui <wenhui.li@datacraft-asia.com> wrote: >
It seems that the switch port which connect to the
> R5 can't pass the
> broadcast which rip and igrp use to send their
> routing table.
> hope it help.
>
> Thanks and Best regards
> Li Wenhui

• Next message: Jason Graun: "Dlsw Bridge Group between two Ethernet interfaces"
• Previous message: Li Wenhui: "Re: problem between ISL and RIP,IGRP with config(again)"
• Maybe in reply to: sherry huies: "problem between ISL and RIP,IGRP with config(again)"
• Next in thread: Li Wenhui: "Re: problem between ISL and RIP,IGRP with config(again)"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:18 GMT-3