Re: problem between ISL and RIP,IGRP with config

From: alain faure (alainfaure@xxxxxxxx)
Date: Mon Feb 11 2002 - 10:16:18 GMT-3


   
Hello,

There is some thingh i don't get :
> R6's interface is a Fastethernet 0/0.1(175.3.56.6/24)

> interface FastEthernet0/1.10
> encapsulation isl 10
> ip address 175.3.56.6 255.255.255.0

Have you check the right sub interface; and the vlan declared on the catalyst ?
It must be VLAN 10 for R5 fastethernet and same VLAN 10 for R6 fa0/0.10 as you
did.

Best regard

 --- sherry huies <cholscurry@yahoo.co.kr> a icrit : > Hi all,
>
> I have a problem on catalyst ISL Trunk problem.
> my R5-router's loopback0 is 175.3.5.0/24.
> R5 is connected to R6 via Fastethernet(175.3.56.5/24)
> R6's interface is a Fastethernet 0/0.1(175.3.56.6/24)
>
> between R5 and R6, if i run OSPF or EIGRP,
> R6's routing table is good.
> R6 has the 175.3.5.0 on its routing table.
>
> but, if i run RIP or IGRP between R5 and R6,
> R6 doesn't have the 175.3.5.0 on its routing table.
>
> of course, R6 has the 175.3.5.0 in a short time.
> but after a while, 175.3.5.0 is possibly down
> and disappeared on R6 routing table.
>
> so when i try to debug on R5 and R6,
> R5 continue to send the 175.3.5.0 to R6,
> but, on R6, the receiving debug message dose not show.
>
>
> If i change the R6's ISL FastEthernet
> to main FastEthernet
> all routing protocol(including RIP,IGRP) is good.
>
> is there any problem between ISL and RIP,IGRP?
> Any suggestions on what I am doing wrong?
>
> =======================================================
> R5#sh run
> interface Loopback0
> ip address 175.3.5.5 255.255.255.0
>
> interface FastEthernet0/0
> ip address 175.3.56.5 255.255.255.0
>
> router igrp 500
> network 175.3.0.0
>
> Rack01R5#sh ip route
> Gateway of last resort is not set
> C 175.3.5.0 is directly connected, Loopback0
> C 175.3.56.0 is directly
> connected,FastEthernet0/0
> I 175.3.6.0 [100/610] via 175.3.56.6,
> 00:01:06, FastEthernet0/0
> =======================================================
> R6#sh run
> interface Serial0/0
> ip address 175.3.6.5 255.255.255.0
>
> interface FastEthernet0/1
> no ip address
>
> interface FastEthernet0/1.10
> encapsulation isl 10
> ip address 175.3.56.6 255.255.255.0
> !
> interface FastEthernet0/1.20
> encapsulation isl 20
> no ip address
>
> router igrp 500
> network 175.3.0.0
>
> R6#sh ip route
> Gateway of last resort is not set
> C 175.3.6.0/24 is directly connected,Serial0/0
> C 175.3.56.0/24 is drectly
> connected,FastEthernet0/0.10
> I 175.3.5.0/24 [100/610] via 175.3.56.5,
> 00:00:00, FastEthernet0/1.10
> =======================================================
>
> 1~2 minute later R6's table
>
> R6#sh ip route
> Gateway of last resort is not set
> C 175.3.6.0/24 is directly connected,Serial0/0
> C 175.3.56.0/24 is drectly
> connected,FastEthernet0/0.10
> I 175.3.5.0/24 is possibly down,
> routing via 175.3.56.5, FastEthernet0/1.1
> ======================================================
>
> if i change the R6's ISL interface to main interface,
> this problem is disappeared at once.
>



This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:18 GMT-3