From: Lupi, Guy (Guy.Lupi@xxxxxxxxxxxxx)
Date: Sun Feb 10 2002 - 17:20:31 GMT-3
Hey guys, I have a problem with priority queueing. I have priority queueing
configured on 2 2600's, working no problem. I have it configured on 2500's
and I can't seem to get it to work correctly. On one of the 2500's I am
trying to have any IP coming from 133.7.24.4 go into the high queue. Here
is my config:
access-list 190 permit ip host 133.7.24.4 any
priority-list 1 protocol ip high list 190
interface Serial0
ip address 133.7.24.2 255.255.255.0
encapsulation ppp
no ip mroute-cache
no peer neighbor-route
priority-group 1
clockrate 1300000
compress stac
ppp authentication chap
ppp chap hostname johnny
This is the config of the router directly connected to the 133.7.24.4
interface, so when anything comes in from 133.7.24.4 it should go into the
high queue right? I am finding that is not the case, when I do a ping from
133.7.24.4 to anywhere, it is going into the normal queue. I would
appreciate any help, the evidence of it going into the normal queue is
below, this is the output of a debug priority on the router directly
connected to 133.7.24.4 after doing a ping from 133.7.24.4.
04:28:53: PQ: Serial0: ccp (defaulting) -> normal
04:28:53: PQ: Serial0 output (Pk size/Q 36/2)
04:28:53: PQ: Serial0: ccp (defaulting) -> normal
04:28:53: PQ: Serial0 output (Pk size/Q 27/2)
04:28:53: PQ: Serial0: ccp (defaulting) -> normal
04:28:53: PQ: Serial0 output (Pk size/Q 28/2)
04:28:53: PQ: Serial0: ccp (defaulting) -> normal
04:28:53: PQ: Serial0 output (Pk size/Q 27/2)
04:28:53: PQ: Serial0: ccp (defaulting) -> normal
04:28:53: PQ: Serial0 output (Pk size/Q 27/2)
04:28:55: PQ: Serial0 output (Pk size/Q 16/0)
04:28:55: PQ: Serial0 output (Pk size/Q 16/0)
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:18 GMT-3