From: Geoff Zinderdine (geoffz@xxxxxxxxxxxxxxxxxx)
Date: Wed Feb 06 2002 - 05:37:47 GMT-3
Change the encap on the serial int. Make sure you save any
encapsulation dependent config first!!
Geoff Zinderdine
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Antonio Marfil
Sent: Wednesday, February 06, 2002 2:12 AM
To: ccielab@groupstudy.com
Subject: How to test a BRI backup int?
is there any way to test a backup int without physically disconnecting
the
serial int that you are trying to backup? shutting down a serial
interface
for example, when the backup int is a bri doesn't do the trick, but
pulling
the cable from the serial int does (automatically brings up the bri
int.)
thanks,
tony
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:12 GMT-3