route filtering question

From: michael robertson (michael_w_2ca@xxxxxxxx)
Date: Tue Feb 05 2002 - 01:08:44 GMT-3

• Next message: Donahue, Gary: "Multilink interface vs. Virtual Templates"
• Previous message: Joe Morabito: "CET or IPSEC"
• Next in thread: Chua, Parry: "RE: route filtering question"
• Maybe reply: Chua, Parry: "RE: route filtering question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi, Group,

I am practising Jeff's book on Page 800 Question 6, it
seems that the solution is wrong.i tried and it never
works.

The solution said that you have to configure
dinstance under IS-IS domain with command

distance 255 192.168.10.241 0.0.0.0 1
access-list 1 permit any.

I think that this is not correct because the first
part of the question is to accept routes only from
router A. In the solution, it doesn't show this part.

i think that what the solution has done is just to
answer the second part of the question. Once A fail. D
will not accept any router from router B, But router D
can still accept routes from router B from EIGRP
domain which is not clearly answered by the solution.

Any comments on this or what's the correct solution.

Regards

michael

• Next message: Donahue, Gary: "Multilink interface vs. Virtual Templates"
• Previous message: Joe Morabito: "CET or IPSEC"
• Next in thread: Chua, Parry: "RE: route filtering question"
• Maybe reply: Chua, Parry: "RE: route filtering question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:11 GMT-3