From: Stephen C. Feldberg (scfeldberg@xxxxxxxxxxx)
Date: Wed Jan 09 2002 - 21:05:45 GMT-3
A previous thread
http://www.groupstudy.com/archives/ccielab/200111/msg00784.html
noted some issues with rif pass-thru using direct encapsulation, perhaps
they are applicable to your scenario as well.
1). No local-peer ip address is required for this type of encapsulation
2). Try recreating the scenario on the physical interface rather than
sub-if.
Steve
----- Original Message -----
From: "Bryan Ginman" <ginmanb@westnet.com>
To: "CCIE" <ccielab@groupstudy.com>
Sent: Wednesday, January 09, 2002 11:21 AM
Subject: DLSW lite
> I am trying to use DLSW lite one side has
>
> dlsw bridge 1
> dlsw local peer X.X.X.X
> dlsw remote 1 frame int serial 0.1 110
> dlsw bgroup 1 bgroup 1
>
> Serial 0.1 m
> Frame map llc2 110 broad
>
> The other side has:
>
> dlsw bridge 1
> dlsw local peer Y.Y.Y.Y (do I have to do this stuff, sorry little joke)
> Promiscuous
>
> Serial 0/0
> Frame map llc2 111 broad
>
> it will not set up the circuit do I need a remote peer even though it is
in
> Promiscuous mode?
>
> Cheers,
>
> Bryan
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:22 GMT-3