From: Richard Geiger (geiger_rich@xxxxxxxxxxx)
Date: Tue Jan 08 2002 - 05:23:55 GMT-3
You must provide a metric (or default metric) when you route between
protocols. Also be-careful with RIP IGRP on the same router, you will
usually find that you interfaces will have both RIP and IGRP at the same
time. (Sh ip Protocol). If this is the case you a route-map to deny local
networks and permit anything from either the rest of the IGP domain in
question. For the settings Chau has it right. -Rich
>From: "Chua, Parry" <Parry.Chua@compaq.com>
>Reply-To: "Chua, Parry" <Parry.Chua@compaq.com>
>To: "Steven" <adream@163.com>, "ccielab" <ccielab@groupstudy.com>
>Subject: RE: redistribute rip route to igrp
>Date: Tue, 8 Jan 2002 14:30:44 +0800
>
>I don't think so. Your example said that you are going to redistribute
>from another routing process with what ever parameters that you set may
>suit for a particluar conditions.
>
>In your example, the bandwidth is 10Mbite ethernet speed, the total
>delay 1000 us.There are some basic guide, you have to watch the
>bandwidth along the path and total delay (for the case of IGRP), pick
>the lower badwidth for bandwidth, add up the total delay as delay
>times. ( you may pick the lower bandwidth a long the igrp path and total
>delay of the IGRP path to ensure that what ever redistributed will not
>be better than any route learn from this routing process)
>
>Parry Chua
>
>-----Original Message-----
>From: Steven [mailto:adream@163.com]
>Sent: Tuesday, January 08, 2002 2:00 PM
>To: ccielab
>Subject: Re: redistribute rip route to igrp
>
>
>does the following value work in any circumstance?It 's from CCO.
>
>"Use the default-metric statement to set the metric for the
>redistributed routes. The following statement is appropriate for most
>cases: "
>
> router igrp n
> default-metric 10000 100 255 1 1500
>
>----- Original Message -----
>From: "Steven" <adream@163.com>
>To: "ccielab" <ccielab@groupstudy.com>
>Sent: Tuesday, January 08, 2002 12:13 PM
>Subject: redistribute rip route to igrp
>
>
> > When i redistribute rip route to igrp process,do i have to input all
>the 5 metric ?
> >
> > how to get the metric value ?
> >
> > Thanks.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:20 GMT-3