From: Abu Hadee (ciscotrng@xxxxxxxxx)
Date: Mon Jan 07 2002 - 04:52:46 GMT-3
Well, i had same problem. but i found the problem with the terminal
application. I tried with other pc, and without any problem it worked.
Well, i dont have any idea what's ur problem, i just wanted to share my
experience.. hope this helps.
thanks
----- Original Message -----
From: "Ma Gang" <matthen@zisco.com.cn>
To: "'ccie lab'" <ccielab@groupstudy.com>
Sent: Sunday, January 06, 2002 10:53 PM
Subject: My router is dying...
> Dear Folks,
>
> Many thanks to whom responded my mail. But they all failed.
>
> The key point of this issue is "Keyboard hitting has no reaction when it
is
> booting".
>
> Anyway, I believe it must be some speed setting under line console 0 and
> hope there is no such "no service password-recovery" command.
>
> Let it be...
>
>
> Regards
>
> Matthew Ma
>
>
>
>
>
>
>
>
>
>
> --- Ma Gang <matthen@zisco.com.cn> wrote:
> > Dear All,
> >
> > I got a wounded 2611 router, its config register may
> > be revised by somebody.
> > The symptom is
> >
> > 1. It can boot and shows the booting message on the
> > normal 9600/8/N/1
> > console.
> >
> > 2. It has NO response when you hit the keyboard
> >
> > 3. There is also no reaction when you try to
> > CTRL+BREAK when it is booting
> >
> > 4. You can access it by AUX port, but only User
> > Mode. It says "no enable
> > password set" when you try to enter Privilege Mode.
> >
> > 5. I have tried alternative CON setting such as
> > speed and stopbits but
> > failed.
> >
> > 6. It does have configuration in its NVRAM.
> >
> >
> > Can anybody save my poor router?
> >
> > Thanks.
> >
> >
> > Regards
> >
> > Matthew Ma
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:18 GMT-3