From: Michael Popovich (m.popovich@xxxxxxxx)
Date: Sat Dec 22 2001 - 20:08:46 GMT-3
This is what Cisco Error Message Decoder returned:
1. %SYS-3-BADRESID: Clock hardware returned bad residual [dec].
A software error has occurred.
Recommended Action: Copy the error message exactly as it appears on the
console or in the system log, call your Cisco technical support
representative, and provide the representative with the gathered
information.
I have never had this error before but what I have had sys-3 errors related
to software issues. It happened to me right after upgrading and rebooting
the system. I was using network modules. What I did was remove the network
modules on the first reboot, then shutdown the system, reinstalled the
network modules and rebooted. Everything worked fine after that. Not sure if
you are using a router with NM.
Hope this helps.
MP
----- Original Message -----
From: "David Vu" <dd_vu@yahoo.com>
To: "CCIE GROUPSTUDY" <ccielab@groupstudy.com>
Sent: Saturday, December 22, 2001 4:53 PM
Subject: Line Protocol going up/down...
> My line protocol keeps going up and down constantly. I finally rebooted
> the router and see this
>
> SYS-3-BADRESID: Clock hardware returned bad residual 0
>
> Can someone please shed some light?
>
> Thanks,
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:46 GMT-3