From: Chris Larson (clarson52@xxxxxxxx)
Date: Sat Dec 22 2001 - 00:45:32 GMT-3
You need to add a
frame-relay map clns "dlci"
to get the ISIS to go.
----- Original Message -----
From: "Richard Geiger" <geiger_rich@hotmail.com>
To: <ccielab@groupstudy.com>
Sent: Friday, December 21, 2001 9:08 PM
Subject: Basic ISIS - strange results - Please Help!!!
> Help...!!!
>
> Jan 8th test date.
>
> I am using 4 cisco 4500 routers, and am walking through the various
> protocols.
> I have completed RIP IGRP EIGRP OSPF so far. So the base configuration is
> fine.
>
> My ISIS configuration is straight forward. I have taken off all but the
> basic configurations on the routers.
>
> CLNS ROuting
>
> Router ISIS
> net 00.0002.<MAC_ADDRE E0>
>
> Int ser 0
> <frame with ip map>
> ip router isis
> Int ser 1
> <hdlc>
> ip router isis
> Int E0
> ip router isis
>
> debug isis adj.
>
> On the frame interfaces I am getting "encapsulation failed" in the debug.
> On the HDLC and Ether the neighbors are talking to each other but I am
> getting "Malformed packets"
>
> Adjacenicies are never set up....????
>
> Ping, telnet, ipsec, nat, etc... is working fine. This is a ISIS issue.
> I am using Enterprise Plus 3des 12.1 (7?).
>
> Any Ideas.......
>
> -Rich
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:46 GMT-3