From: tom cheung (tkc9789@xxxxxxxxxxx)
Date: Sat Dec 22 2001 - 00:26:47 GMT-3
On your frame interface, did you configure frame map clns xxx broad?
If I remember correctly, ISIS does not support p2mp either. Something to
watch out for.
HTH
>From: "Richard Geiger" <geiger_rich@hotmail.com>
>Reply-To: "Richard Geiger" <geiger_rich@hotmail.com>
>To: ccielab@groupstudy.com
>Subject: Basic ISIS - strange results - Please Help!!!
>Date: Fri, 21 Dec 2001 20:08:13 -0600
>
>Help...!!!
>
>Jan 8th test date.
>
>I am using 4 cisco 4500 routers, and am walking through the various
>protocols.
>I have completed RIP IGRP EIGRP OSPF so far. So the base configuration is
>fine.
>
>My ISIS configuration is straight forward. I have taken off all but the
>basic configurations on the routers.
>
>CLNS ROuting
>
>Router ISIS
>net 00.0002.<MAC_ADDRE E0>
>
>Int ser 0
><frame with ip map>
>ip router isis
>Int ser 1
><hdlc>
>ip router isis
>Int E0
>ip router isis
>
>debug isis adj.
>
>On the frame interfaces I am getting "encapsulation failed" in the debug.
>On the HDLC and Ether the neighbors are talking to each other but I am
>getting "Malformed packets"
>
>Adjacenicies are never set up....????
>
>Ping, telnet, ipsec, nat, etc... is working fine. This is a ISIS issue.
>I am using Enterprise Plus 3des 12.1 (7?).
>
>Any Ideas.......
>
>-Rich
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:46 GMT-3