From: kenairs (kenairs@xxxxxxxxxxx)
Date: Fri Dec 21 2001 - 14:47:29 GMT-3
Hi ,
I need to do authentication for let's say area 5.
All routers in area 5 has each got a loopback address configure.
Loopback0 is up, line protocol is up
Internet Address 100.10.1.1/24, Area 0
Process ID 1, Router ID 100.10.1.1, Network Type POINT_TO_POINT, Cost: 1
Transmit Delay is 1 sec, State POINT_TO_POINT,
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 00:00:00
Neighbor Count is 0, Adjacent neighbor count is 0
Suppress hello for 0 neighbor(s)
Message digest authentication enabled
No key configured, using default key id 0
My question is since i have configure authentication for the entire area 5 ,
do i need to assigned a key ( password ) to all the loopback address in all
the routers ??
I do think so. But i hope for some opinion.
Tks
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:46 GMT-3