From: Michael Popovich (m.popovich@xxxxxxxx)
Date: Tue Dec 18 2001 - 01:43:41 GMT-3
Thanks Kym for your reply.
I just bought some Flash for this thing and will upgrade the IOS this week
and see if I have any problems.
I just re-read my email and it reads about as badly as I feel right now. Not
much sleep lately. :):) Sorry for the poor grammer on that one.
Thanks again.
MP
----- Original Message -----
From: "kym blair" <kymblair@hotmail.com>
To: <m.popovich@home.com>; <ccielab@groupstudy.com>
Sent: Monday, December 17, 2001 10:35 PM
Subject: Re: 2523 Question
> Michael,
>
> I use a 2520 for my frame switch; S0 and S1 are standard serial and S2 and
> S3 are asynch. I connect all four to standard serial ports on routers and
> set my clock rate at 56K or 64K; never a problem. Sometimes I run the DTE
> on the frame switch and put the DCE on the router; still no problem.
>
> OT: One guy described on groupstudy a few months ago how to connect two
2501
> routers via their eithernet port and turn the pair into a frame relay
switch
> with four serial interfaces using tunnels across the ethernet link. I
> tested his design and it worked great.
>
> If you continue to have a problem, I'd recommend write erase and reprogram
> your frame switch.
>
> Kym
>
>
>
>
>
> >From: "Michael Popovich" <m.popovich@home.com>
> >Reply-To: "Michael Popovich" <m.popovich@home.com>
> >To: "CCIE GROUPSTUDY" <ccielab@groupstudy.com>
> >Subject: 2523 Question
> >Date: Mon, 17 Dec 2001 22:15:43 -0600
> >
> >On the 2523 or 2522 does anyone know which 2 ports are the High Speed
> >Async? I
> >think they are S0 and S1. If so has anyone every had problems doing
> >frame-relay switching between a high speed and low speed interface? For
> >example between serial 0 and serial 2 with clockrates set at 64000.
> >
> >I was having an issue tonight in which I was doing frame-switching
between
> >those exact two interfaces at 64000 bits. I could not get Serial 0 to
come
> >up.
> >LMI kept timing out. I have never had any problems before with this port
> >and
> >have used in not doing frame-switching. I replaced cables and that didn't
> >help. I finally just put the DCE cable into Serial 3 and everything works
> >fine.
> >
> >Any thoughts?? Using 11.0(10.3) IOS.
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:44 GMT-3