bitswap-layer3-addresses

From: KK FoK (rgb98a@xxxxxxxxxxx)
Date: Wed Dec 12 2001 - 01:30:46 GMT-3

• Next message: chih_chung@xxxxxxxxxxx: "ISDN Line problem"
• Previous message: KK FoK: "mac filter under token ring"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi group,

I'm not sure under what circumstances we need "bridge 1
bitswap-layer3-addresses".

Is it mandatory when we do SR/TLB with a mix of ethernet and token
interfaces ?

I did some searches but could not find a sample config where we need this
command. The sample configuration for SR/TLR provided by Cisco does not have
that "bridge 1 bitswap-layer3-addresses".

source-bridge ring-group 10
source-bridge transparent 10 3 1 1
!
interface tokenring 0
source-bridge 1 1 10
!
interface tokenring 1
source-bridge 2 1 10
!
interface ethernet 0
bridge-group 1
!
interface ethernet 1
bridge-group 1
!
bridge 1 protocol dec

• Next message: chih_chung@xxxxxxxxxxx: "ISDN Line problem"
• Previous message: KK FoK: "mac filter under token ring"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:42 GMT-3