From: Menga, Justin (Justin.Menga@xxxxxxxxxx)
Date: Tue Dec 11 2001 - 23:50:20 GMT-3
Sorry, I misread your config, I thought R2 was performing SRB...
Because R2 is not performing SRB, it sends frames without a RIF.
Therefore, you must enable SRT on R1 to make this work. This is done
by:
R1:
int to0
bridge-group 1
Regards,
Justin
-----Original Message-----
From: kyle prevey [mailto:preveyk@hotmail.com]
Sent: Wednesday, 12 December 2001 11:59 a.m.
To: ccielab@groupstudy.com
Subject: Can't get translational bridging to work!
In my home lab, I setup R1 as a translational bridge and I put R2 on the
token segment and put R3 on the Ethernet segment but they don't talk.
Here
is the config:
R1
source-bridge ring-group 10
source-bridge transparent 10 3 1 1
!
int e0
no ip add
bridge-group 1
!
int to0
no ip add
source-bridge 1 1 10
ring 16
!
end
R2
int to0
ip add 10.1.1.1 255.255.255.0
ring 16
!
end
R3
int e0
ip add 10.1.1.2 255.255.255.0
!
end
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:42 GMT-3