From: Rajeev Siddappa (raj_lab@xxxxxxxxx)
Date: Sat Dec 01 2001 - 22:20:26 GMT-3
OSPF treats any loop back interface address as host
address. U can change this behaviour by entering the
command
IP OSPF network point-to-point.
Rajeev.
--- fathallah said <sfathallah@mail.cbi.net.ma> wrote:
> Hello Group,
>
> I have this config :
>
> Loopback0----R1<----------->R2<---------------->R3
>
> The 3 router are running OSPF area 0 . I have
> defined the loopback0 with :
> 128.103.88.129 / 28.
> but in the R3 routing table the ospf give network
> 128.103.88.129 / 32.
>
> it is normal that ospf advertise always the loopback
> with 32 mask bit ?.
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:35 GMT-3