From: Bauer, Rick (BAUERR@xxxxxxxxxxx)
Date: Tue Nov 27 2001 - 11:33:12 GMT-3
Yes, but you must use the set interface option in the route map.
router rip
network x.x.x.x
default-information originate route-map defgate
!
route-map defgate permit 10
match ip address 1
set interface s0
!
access-list 1 permit x.x.x.x y.y.y.y
-----Original Message-----
From: Chua, Parry [mailto:Parry.Chua@compaq.com]
Sent: Monday, November 26, 2001 11:33 PM
To: Vincent Zhang; Ali Fahmi; ccielab@groupstudy.com
Subject: RE: default information origination
Hi,
You use
> "default-information originate route-map"
*****************************
and if there is a default route orginate from other routers propagate to
you
the above will not work.
Parry Chua
-----Original Message-----
From: Vincent Zhang [mailto:vincentzhang@yahoo.com]
Sent: Tuesday, November 27, 2001 3:10 AM
To: Ali Fahmi; ccielab@groupstudy.com
Subject: Re: default information origination
The route-map in your config only defines the condition to meet to
advertise
default route.
in your case, use "distribute-list out interface xx"
----- Original Message -----
From: "Ali Fahmi" <afahmi@plasa.com>
To: <ccielab@groupstudy.com>
Sent: Monday, November 19, 2001 2:15 PM
Subject: default information origination
> Hi All,
> Is it possible to send 0/0 update to selected interface in
> RIP ver 1 (e.g. Serial 0/0 ) ?
>
> I've tried to create a route-map and use
> "default-information originate route-map"
> but I still found 0/0 was sent to every interface,
>
> Thanks,
>
> Rgds,
> ---------------------------------------------------------
> NETKUIS berhadiah ratusan juta Rupiah : (http://netkuis.plasa.com)
> Email ini dikirim oleh PlasaCom : (http://www.plasa.com)
> ---------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:23 GMT-3