From: michael robertson (michael_w_2ca@xxxxxxxx)
Date: Fri Nov 23 2001 - 02:42:44 GMT-3
Hi, Young,
I have used the same prefix as you can see, but the
problem here is that whenever I specify an arbitrary
nsap address, it will not work. I can't ping to other
side.
Any recommendation?
regards
michael
--- Young Brown <lybrown@cisco.com> wrote:
> Yes, you should use the same nsap prefix as the
> ls1010 switch to identify
> the arp-server.
>
> -----Original Message-----
> From: nobody@groupstudy.com
> [mailto:nobody@groupstudy.com]On Behalf Of
> michael robertson
> Sent: Thursday, November 22, 2001 9:22 PM
> To: ccielab@groupstudy.com
> Subject: why my router doesn't recognize atm NSAP
> address
>
>
> Dear group,
>
> I have practiced atm lately, and the atm switch is
> lightstream 1010.
>
> I have tried to assign the atm nsap address with esi
> address, I can ping between two routers, If I assign
> the atm nsap address with the following command,
> atm nsap-address
> 47.009181000000001007386501.888888888888.00 ,
>
> then I have no luck to ping other side. I debug atm
> signal, and it says that E164 is not converted. In
> this scenario, does this mean that lightstream can't
> allow youself to assign your own atm address and the
> only way you have to do is use atm esi address??
>
> Question 2:
>
> If I can assign atm nsap address, the first 13 bytes
> should be identical to ATM switch or not?
>
>
> Regards
>
> michael
>
>
> ------R1-------ATM lightstream 1010------R2----
>
>
>
>
> Configuration is as follows:
>
> R1
>
> r1#sh run int atm2/0
> Building configuration...
>
> Current configuration:
> !
> interface ATM2/0
> ip address 200.10.11.16 255.255.255.0
>
> map-group 1483svc
> atm nsap-address
> 47.009181000000001007386501.999999999999.00
> no atm scrambling cell-payload
> atm pvc 5 0 5 qsaal
> no atm ilmi-keepalive
> end
>
> map-list 1483svc
> ip 200.10.11.15 atm-nsap
> 47.009181000000001007386501.888888888888.00
> broadcast
>
> -------------------------------
>
> R2:
>
> interface ATM2/0
> ip address 200.10.11.15 255.255.255.0
> map-group 1483svc
> atm nsap-address
> 47.009181000000001007386501.888888888888.00
> no atm scrambling cell-payload
> atm pvc 5 0 5 qsaal
> no atm ilmi-keepalive
> end
>
> map-list 1483svc
> ip 200.10.11.16 atm-nsap
> 47.009181000000001007386501.999999999999.00
> broadcast
>
>
>
>
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:21 GMT-3