From: Jason Graun (jgraun@xxxxxxxxxx)
Date: Tue Nov 20 2001 - 16:00:23 GMT-3
Do You have any documentation on that feature of voice?
Thanks
Jason
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Andy Cuberly
Sent: Tuesday, November 20, 2001 8:00 AM
To: 'fwells12'; ccielab@groupstudy.com
Subject: RE: Can someone verify this voice config please.
Almost there - You need to insert a single "." before the capital "T" in
the
destination pattern in the VOIP dial peer.
Looks like this:
destination-pattern .T
Also - You need to add a valid extension number in the Pots dial peer on
the
destination pattern line.
example:
R1
dial-peer voice 1 pots
destination-pattern 111
port 1/0/0
dial-peer voice 2 voip
destination-pattern .T
session target ipv4:x.x.x.x (IP address of R2)
The rest looks good.
Andy Cuberly
CCIE #8386
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
fwells12
Sent: Tuesday, November 20, 2001 12:50 AM
To: ccielab@groupstudy.com
Subject: Can someone verify this voice config please.
I don't have voice access to try this. The object of the excersize is
to be
able to use any number to dial over frame-relay to another phone and
have
that
phone be able to dial back using any number too.
R1-----------frame-relay ------------R2
R1
dial-peer voice 1 pots
destination-pattern T
port 1/0/0
dial-peer voice 2 voip
destination-pattern T
session target ipv4:x.x.x.x
R2
dial-peer voice 1 pots
destination-pattern T
port 1/0/0
dial-peer voice 2 voip
destination-pattern T
session target ipv4:x.x.x.x
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:19 GMT-3