From: tom cheung (tkc9789@xxxxxxxxxxx)
Date: Sun Nov 18 2001 - 23:45:04 GMT-3
Let me take a shot at this.
dmac-output-list when configured on a remote-peer statement will tell the
local peer that for this remote peer, only mac addresses defined in the list
are reachable.
icanreach mac-addr is used to tell the remote peers which mac-addresses are
reachable for this local peer. The mac-address format should be
H.H.H F.F.O not 0.0.F.
>From: lgao <lgao@cisco.com>
>Reply-To: lgao <lgao@cisco.com>
>To: group <ccielab@groupstudy.com>
>Subject: DLSW mac address filter
>Date: Sun, 18 Nov 2001 17:49:00 -0800
>
>Here is the question,
>
>dmac-output-list will filter out the explorer's destination mac address.
>
>The following command set only permit explorer packet with certain mac
>addr
>{
> dlsw icanreach mac-addr H.H.H 0.0.F
> dlsw icanreach mac-exclusive
>}
>
>so in that sense, I can use either way to make a mac address filter of
>DLSW.
>Is that correct?
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:18 GMT-3